Engineering, 14.12.2019 05:31 kingdrex4772

A15.24 cm long, 1.27 cm diameter 304 stainless steel rod is being reduced in diameter to 1.2192 cm by turning on a lathe. the spindle rotates at n=400 rpm, and the tool is travelling at an axial speed of 20.32 cm/min. calculate the cutting speed, material removal rate, power dissipated, and cutting force.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms

Answers: 2

Answer

You know the right answer?

A15.24 cm long, 1.27 cm diameter 304 stainless steel rod is being reduced in diameter to 1.2192 cm b...

Questions