subject
Engineering, 12.12.2019 03:31 andreamartinez375

Air at 1600 k, 30 bar enters a turbine operating at steady state and expands adiabatically to the exit, where the pressure is 2.4 bar. the isentropic turbine efficiency is 90%. assume ideal gas behavior for the air and ignore kinetic and potential energy effects.

determine the temperature at the exit, in k, and the work developed, in kj per kg of air flowing.

q1/

the isentropic efficiency for a turbine operating with an ideal gas is evaluated in terms of the specific enthalpy at the actual exit state (h2) and the specific enthalpy at the exit state for isentropic expansion (h2s) as:

a

option a: (h1 – h2s) / (h1 – h2)

b

option b: (h1 – h2) / (h2s – h1)

c

option c: (h2s – h1) / (h1 – h2)

d

option d: (h1 – h2) / (h1 – h2s)

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
question
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160Β°f. a computer code is appropriate for solving this problem.
Answers: 3
You know the right answer?
Air at 1600 k, 30 bar enters a turbine operating at steady state and expands adiabatically to the ex...
Questions
Questions on the website: 13722360