Engineering, 12.12.2019 01:31 comeonmanim

Design a feedback control system for the plant such that the following three control objectives are all met: objectivel: the steady-state value of the output for input r(t) 1 is at least 0.9; objective2: the output reaches 95% of its final value no later than 0.1s; objective3: the overshot (%mp) is less than 5% r(s) c(s) plant controller 10 h(s) s +10 (a) (25pts) as a first try, consider a simple proportional controller h(s) kp. determine the range of value for kp that meets the three objectives. (b) (25pts) now consider a more complex pl controller hos) kp kl/s. determine a set of kp and kl values that meet the three objectives.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 19:10

What is creep? what is stress relaxation?

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Abarometer contains mercury with a density of 13600 kg/m3. atmospheric conditions are 95.8 kpa and 20 °c at 20 °c, the vapor pressure of the mercury is 0.000173 kpa. the column of mercury will rise to a height of most nearly. select one: a)- 0.38 m b)- 0.82 m c)- 0.48 m d)- 0.72 m

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Apiping systems consists of 6 m of 6-std type k and 12 m of 4-std type k, both drawn copper tubing. the system conveys ethylene glycol at a rate of 0.013 m3/s. the pressure drop across the system is to be calculated. there are two 90° elbows in the 6-in pipe, a reduction from the 6-in pipe to the 4-in pipe and four 90° elbows in the 4-in pipe. all fittings are soldered (same as flanged) and regular. the inlet and outlet of the system are at the same height.

Answers: 1

Answer

You know the right answer?

Design a feedback control system for the plant such that the following three control objectives are...

Questions