Engineering, 11.12.2019 18:31 xyzendre

Acontinuous and aligned fibrous reinforced composite having a cross-sectional area of 970 mm2 is subjected to an external tensile load. if the stresses sustained by the fiber and matrix phases are 215 mpa and 5.38 mpa, respectively, the force sustained by the fiber phase is 76,800 n, and the total longitudinal composite strain is 1.56 × 10-3 , determine the following: (a) the force sustained by the matrix phase (b) the modulus of elasticity of the composite material in the longitudinal direction (c) the moduli of elasticity for fiber and matrix phases

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

What is the heat treatment of metals? what is the benefit of it? why and how it's useful? answer in details, do not write by hand.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed

Answers: 3

Answer

You know the right answer?

Acontinuous and aligned fibrous reinforced composite having a cross-sectional area of 970 mm2 is sub...

Questions