Engineering, 07.12.2019 00:31 janyiareese12

Write a program that creates a directory containing course numbers and the room numbers of the rooms where the courses meet. the dictionary should have the following key-value pairs: course number (key) room number (value) cs101 3004 cs102 4501 cs103 6755 nt110 1244 cm241 1411 the program should also create a dictionary containing course numbers and the names of the instructors that teach each course. the dictionary should have the following key-value pairs: course number (key) instructor (value) cs101 haynes cs102 alvarado cs103 rich nt110 burke cm241 lee the program should also create a dictionary containing course numbers and the meeting times of each course. the dictionary should have the following key-value pairs: course number (key) meeting time (value) cs101 8: 00am cs102 9: 00am cs103 10: 00am nt110 11: 00am cm241 11: 00pm the program should let the user enter a course number, and then it should display

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.

Answers: 3

Answer

You know the right answer?

Write a program that creates a directory containing course numbers and the room numbers of the rooms...

Questions