Engineering, 06.12.2019 06:31 rfultz27

Aww plant has ww with 450 mg/l bod (the soluble bod is 250 mg/l) and 280 mg/l ss. the biological tower treatment process consists of high-density, cross-flow packing media with dimensions of 480 sq ft by 20 ft high. the packing has a specific area of 42 sq ft/cubic ft, n = 0.5 and k20 =0.0035 (gpm/sq ft)0.5. the primary clarifier effluent is 0.8 mgd at 18oc. the recirculation ration is 1.0. calculate the effluent soluble bod at 20oc, then correct the calculation for actual temperature. calculate the soluble and total effluent bod assuming that the effluent has 0.54 soluble bod/total bod.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

Engineering, 04.07.2019 19:20

In the winter, in order to keep the classroom steadily at 68 f before 10 pm, heating with an average rate of 42,000 btu/hr is provided. assume the outdoor temperature maintains at 32°f, determine the electrical power (kw) required to (a) operate a reversible heat pump (b) operate a real heat pump with a cop (7) of 4.5 and (c) operate an electrical-resistance heater.

Answers: 3

Answer

You know the right answer?

Aww plant has ww with 450 mg/l bod (the soluble bod is 250 mg/l) and 280 mg/l ss. the biological tow...

Questions

Engineering, 11.07.2019 05:10

Acylindrical metal specimen having an original diameter of 11.80 mm and gauge length of 51.7 mm is pulled in tension until fracture occurs. the diamet...

Engineering, 11.07.2019 05:10

Air is compressed in an isentropic process from an initial pressure and temperature of p1 = 90 kpa and t1=22°c to a final pressure of p2=900 kpa. dete...

Engineering, 11.07.2019 05:10

Is a process that is internally reversible and adiabatic necessarily isentropic? explain using an equation....

Engineering, 11.07.2019 05:10