Engineering, 05.12.2019 18:31 dhailyortegacampa131
Along, cylindrical, electrical heating element of diameter 10 mm, thermal conductivity 240 w/m·k, density 2700 kg/m3, and specific heat 900 j/kg·k is installed in a duct for which air moves in cross flow over the heater at a temperature and velocity of 27°c and 20 m/s, respectively.
(a) neglecting radiation, estimate the steady-state surface temperature when, per unit length of the heater, electrical energy is being dissipated at a rate of 1000 w/m.
(b) if the heater is activated from an initial temperature of 27°c, estimate the time required for the surface temperature to come within 10°c of its steady-state value. evaluate the properties of air at 450 k.
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:20
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
Engineering, 04.07.2019 19:10
What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.
Answers: 1
Engineering, 04.07.2019 19:10
Agas is compressed from vi 0.3 m, p 1 bar to of v2 0.1 m3, p2--3 bar. pressure and volume are related linearly during the process. for the gas, find the work, in kj.
Answers: 2
You know the right answer?
Along, cylindrical, electrical heating element of diameter 10 mm, thermal conductivity 240 w/m·k, de...
Questions
Mathematics, 19.07.2019 14:00
Social Studies, 19.07.2019 14:00
Mathematics, 19.07.2019 14:00
Mathematics, 19.07.2019 14:00
Social Studies, 19.07.2019 14:00
