Engineering, 04.12.2019 04:31 kahnerp6448

8-36 using the batch simulator screen, write a program that will implement the following tank filling and mixing sequence. the start button is pressed to start input pump p1 after 100 gallons (one flowmeter pulse per gallon) input pump p1 stops automatically and the mixer motor starts. o the mixer motor is automatically stopped after 30 seconds, and the input pump p1 is started after an additional 60 gallons are pumped into the tank, the input pump stops and the mixer motor starts. the mixer motor is operated for 20 seconds and stops. o the discharge pump p3 motor is started automatically and runs until the low-level sensor is actuated. the process stops use the following addresses in developing the program start pb : 1/0 stop pb : 1/1 input flowmeter_: 1/5 low-level sensor_ l: 1/3 mixer motor 0: 2/0 oinput pump p1 o: 2/1 discharge pump p3_ o: 2/3 ointernal relay_ b3: 0/0 o ctu c5: 1 o ctu c5: 2 orto t4: 1 orto t4: 2 o c

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

A)-in the process of engineering design, explain the contribution of material selection. b)- explain the procedure of synthesis as is employed in engineering design. c)- is there any relationship between ergonomics and engineering design? explain. d)- safety consideration in engineering design includes human, product and the enviroment . explain how safety will be incorporated into the design?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Acompressor compresses a gas, a pump compresses a liquid. for a given pressure ratio, why does it take more work to compress a gas in a compressor than a liquid in a pump? a)- for a given pressure ratio the average specific volume for a gas is much higher than the average specific volume for a liquid. b)- there is no difference. the only difference is the amount of heat generated (not work) c)- for a given pressure ratio the average volurge for a gas is much higher than the average volume for a liquid. d)-there is no difference

Answers: 3

Answer

You know the right answer?

8-36 using the batch simulator screen, write a program that will implement the following tank fillin...

Questions