Engineering, 28.11.2019 01:31 BeeShyanne

Prepare a schedule for the following situation: the forecast is 80 units for each of the first two periods and 60 units for each of the next three periods. the starting inventory is 20 units. the company uses a chase strategy for determining the production lot size, except there is an upper limit on the lot size of 70 units. also, the desired safety stock is 10 units. note: the atp quantities are based on maximum allowable production and do not include safety stock. committed orders are as follows: (negative amounts should be indicated by a minus sign. leave no cells blank - be certain to enter "0" wherever required.)

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Acompressor compresses a gas, a pump compresses a liquid. for a given pressure ratio, why does it take more work to compress a gas in a compressor than a liquid in a pump? a)- for a given pressure ratio the average specific volume for a gas is much higher than the average specific volume for a liquid. b)- there is no difference. the only difference is the amount of heat generated (not work) c)- for a given pressure ratio the average volurge for a gas is much higher than the average volume for a liquid. d)-there is no difference

Answers: 3

Answer

Engineering, 06.07.2019 02:30

An electric motor is used to drive a power press which makes steel turning moment diagrams 323 pressings from a metal sheet. the motor runs at a mean speed of 50 rev/s. the torque required is 10.0nm for 0.2s, followed by 1.0nm for0.3 s with this sequence then being repeated. what is the minimum power required of the motor and the moment of incrtia required for the t1ywhcel if the speed fluctuations are to be restricted to 1.5%?

Answers: 3

Answer

Engineering, 06.07.2019 03:10

How to convert a friction to decimal ?

Answers: 1

Answer

You know the right answer?

Prepare a schedule for the following situation: the forecast is 80 units for each of the first two...

Questions