Engineering, 28.11.2019 00:31 SumayahAminaAnsari

In the final stages of production, a pharmaceutical is sterilized by heating it from 25 to 75 degree c as it moves at 0.2 m/s through a straight thin-walled stainless steel tube of 12.7-mm diameter. a uniform heat flux is maintained by an electric resistance heater wrapped around the outer surface of the tube. if the tube is 10 m long, what is the required heat flux? if fluid enters the tube with a fully developed velocity profile and a uniform temperature profile. what is the surface temperature at the tube exit and at a distance of 0.5 m from the entrance? fluid properties may be approximated as p = 1000 kg/m, c = 4000 j/kg. k. m = 2 x 10^-3 kg/s. m, k = 0.8 w/m. k, and pr = 10. provide step-by-step work and a final answer. i will award points immediately.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

Answer

Engineering, 04.07.2019 19:10

In general, how do thermosetting plastics compare to thermoplastics in mechanical and physical properties?

Answers: 3

Answer

You know the right answer?

In the final stages of production, a pharmaceutical is sterilized by heating it from 25 to 75 degree...

Questions