Engineering, 22.11.2019 04:31 Fluffyboi

Awindow-mounted air conditioner supplies 19 m3/min of air at 15 oc and 1 bar to a room. air returns from the room into the evaporator of the unit at 22oc. the air conditioner operates at steady-state on a vapor-compression refrigeration cycle with refrigerant-22 entering the compressor at 4 bar, 10 oc and exiting at 9 bar. saturated liquid refrigerant leaves the condenser. assuming the compressor has an isentropic efficiency of 70%, determine: (a) the mass flow rate of refrigerant in kg/min,(b) the compressor power, in kw,(c) the refrigeration capacity, and(d) the coefficient of performance.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 03:10

What precautions should you take to prevent injuries when dealing with heavy loads?

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Apiping systems consists of 6 m of 6-std type k and 12 m of 4-std type k, both drawn copper tubing. the system conveys ethylene glycol at a rate of 0.013 m3/s. the pressure drop across the system is to be calculated. there are two 90° elbows in the 6-in pipe, a reduction from the 6-in pipe to the 4-in pipe and four 90° elbows in the 4-in pipe. all fittings are soldered (same as flanged) and regular. the inlet and outlet of the system are at the same height.

Answers: 1

Answer

You know the right answer?

Awindow-mounted air conditioner supplies 19 m3/min of air at 15 oc and 1 bar to a room. air returns...

Questions