Engineering, 20.11.2019 23:31 ale414141

Laminar flow normally persists on a smooth flat plate until a critical reynolds number value is reached. however, the flow can be tripped to a turbulent state by adding roughness to the leading edge of the plate. for a particularsituation, experimental results show that the local heat transfer coefficients for laminar and turbulent conditions are: hlam(x)= 1.74w/m^1.5. kx^-0.5hturb(x)= 3.98w/m^1.98. kx^-0.2 calculate the average heat transfer coefficients for laminar and turbulent conditions for plates of length l = 0.1 m and 1 m.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Amass-spring-viscous damper system of mass 3 kg has a frequency of 100 rad/s and is critically damped. its initial conditions are x(0)-3 mm and (0)-2.3 m/s. does the system overshoot its equilibrium position? prove your answer

Answers: 1

Answer

Engineering, 06.07.2019 04:10

Along steel shaft of 10 cm diameter is austenised at 870°c and then quenched in a liquid at 30oc. the average surface heat transfer coefficient is 2000 w/m2. °c. the relevant thermophysical properties of the shaft are: p=7800 kg/m", k=20 w/mk, cp=0.46 kj/kg.k calculate: a)-the time required for the center temperature to drop to 200°c. b)-the temperature at half-radius at that moment. c)-the amount of heat that had been transferred to the liquid by that time per meter length of the shaft

Answers: 1

Answer

You know the right answer?

Laminar flow normally persists on a smooth flat plate until a critical reynolds number value is reac...

Questions