Engineering, 20.11.2019 20:31 colebash88

Acylindrical tank is required to contain a gage pressure 560 kpa . the tank is to be made of a516 grade 60 steel with a maximum allowable normal stress of 150 mpa . if the inner diameter of the tank is 2.6 m , what is the minimum thickness, t, of the wall? part b - maximum pressure for a cylindera cylindrical tank is made of a516 grade 60 steel with a maximum allowable normal stress of 150 mpa . if the inner diameter of the tank is 4.9 m and the thickness is 1.4 cm , what is the maximum allowable gage pressure? part c - spherical pressure vessela spherical pressure vessel is required to contain 1.9 m3 of compressed natural gas at 23 mpa . if the tank is made of a516 grade 60 steel with a maximum normal stress 150 mpa , what is the required thickness of the tank wall?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.

Answers: 1

Answer

You know the right answer?

Acylindrical tank is required to contain a gage pressure 560 kpa . the tank is to be made of a516 gr...

Questions