Engineering, 15.11.2019 21:31 xlameweirdox

Laminar flow normally persists on a smooth flat plate until a critical reynolds number value is reached. however, the flow can be tripped to a turbulent state by adding roughness to the leading edge of the plate. for a particular situation, experimental results show that the local heat transfer coefficients for laminar and turbulent conditions are:
h lam ( x ) = 1.74 w / m^ 1.5 * k x^ − 0.5
h turb ( x ) = 3.98 w / m^ 1.8 * k x ^− 0.2
calculate the average heat transfer coefficients for laminar and turbulent conditions for plates of length l = 0.1 m and 1 m.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)

Answers: 3

Answer

You know the right answer?

Laminar flow normally persists on a smooth flat plate until a critical reynolds number value is reac...

Questions