Engineering, 15.11.2019 06:31 Itselliekojo2218

A2.4 liter, four stroke cycle engine is equipped with multipoint port fuel injection, having one injector per cylinder. the injectors are constant flow devices, so the fuel flow rate into the engine is controlled by the injection pulse duration. maximum power is obtained at wot when injection duration is continuous. at this condition, engine speed is at 5800 rpm with stoichiometric gasoline and an inlet pressure of 101 kpa. at idle condition, the engine speed is 600 rpm with stoichiometric gasoline and an inlet pressure of 30 kpa. volumetric efficiency can be considered 95% at wot. calculate:

a) fuel flow rate through an injector

b) injection pulse duration in seconds at idle conditions

c) injection pulse duration in degrees of engine rotation at idle conditions

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?

Answers: 1

Answer

You know the right answer?

A2.4 liter, four stroke cycle engine is equipped with multipoint port fuel injection, having one inj...

Questions