subject
Engineering, 15.11.2019 01:31 corbinfisher

Two 0.5 cm-diameter rods of 1020 steel (σts = 395 mpa) are to be joined with a silver braze alloy 0.025 cm thick (σys = 145 mpa) to produce one long rod. the ultimate strength of this brazed structure is found to be approximately 345 mpa. if it is necessary to reduce the diameter of the rods to 0.25 cm with no change to the braze joint itself, will the strength (in mpa units) increase, decrease, or remain the same? if it changes, by how much?

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?
Answers: 3
question
Engineering, 04.07.2019 18:10
The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false
Answers: 1
question
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
question
Engineering, 04.07.2019 18:20
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
You know the right answer?
Two 0.5 cm-diameter rods of 1020 steel (σts = 395 mpa) are to be joined with a silver braze alloy 0....
Questions
question
Mathematics, 10.10.2019 23:30
question
Mathematics, 10.10.2019 23:30
Questions on the website: 13722363