Engineering, 14.11.2019 02:31 wmaingrette1

Give fluent english readings for the following sentences of ple using the given symbolization key. ud: the set of positive integers lxy: x is less than y gxy: x is greater than y ex: x is even ox: x is odd px: x is prime f(x, y): the product of x and y t: 2 f: 5 n: 9 a. (∀x)(∃y)lxy b. (∃x)(∀y)(∼ x y ⊃ lxy) c. (∃x)(∀y) ∼ lyx d. ∼ (∃x)(ex & lxt) e. (pt & et) & (∀x)[(px & ex) ⊃ x t] f. ∼ (∃x)(∃y)[(px & py) & pf(x, y)] g. (∀y)(∀z)[(oy & oz) ⊃ of(y, z)] h. (∀y)(∀z)[(ey & ez) ⊃ ef(z, y)] i. (∀y)(∀z)[(ey ∨ ez) ⊃ ef(y, z)] *j. (∀x)[ex ⊃ (∃y)(oy & gxy)] & ∼ (∀x)[ox ⊃ (∃y)(ey & gxy)] k. (∃x)[[px & (gxf & lxn)] & (∀y)([py & (gyf & lyn)] ⊃ y x)]

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.

Answers: 3

Answer

Engineering, 06.07.2019 02:30

1in2 processor chip can be modelled as an isothermal plane wall of silicon, isothermal on both sides. the power input to the bottom of the plane wall, or the processing power of the chip, often called the thermal design power (tdp), is 100w. assume the periphery is adiabatic. the silicon is 400 microns thick. the temperature at the junction, or in this case on the bottom of the isothermal plane wall, is 85°c. what is the top surface temperature, assuming that the only mode of heat transfer is conduction

Answers: 1

Answer

You know the right answer?

Give fluent english readings for the following sentences of ple using the given symbolization key. u...

Questions