Engineering, 08.11.2019 19:31 keishadawson

An absorption column for laboratory use has been carefully constructed so that it has exactly 4 equilibrium stages and is being used to measure equilibrium data. water is used as the solvent to absorb ammonia from air. the system operates isothermally at 80°f and 1 atm. the inlet water is pure distilled water. the ratio of l/v = 1.2, inlet gas concentration is 0.01 mole fraction ammonia, and the measured outlet gas concentration is 0.0027 mole fraction ammonia. assuming that equilibrium is of the form y = mx, calculate the value of m for ammonia. assume the inlet water contains no ammonia, and assume we are operating in the dilute ammonia concentration regime.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:20

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Aheavily insulated piston-cylinder device contains 0.02 m3 of steam at 300 kpa and 200 °c. 1.2 mpa. d this process. team is now compressed in a reversible manner to a pressure of etermine the entropy change and the work done on the steam during this process

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Which of the following is the most important advantage of a large field of view? a. allows larger areas to be examined b. relieves eyestrain c. minimizes parallax errors. d. increases precision in proportion to the in- crease in field of view

Answers: 2

Answer

You know the right answer?

An absorption column for laboratory use has been carefully constructed so that it has exactly 4 equi...

Questions