Engineering, 07.11.2019 03:31 karinapenn8259

Consider a flat plate subject to parallel flow (top and bottom) characterized by u 5 m/s, t 20 c. (a) determine the average convection heat transfer coefficient, convective heat transfer rate, and drag force associated with an l 2-m-long, w 2-mwide flat plate for airflow and surface temperatures of ts 50 c and 80 c. (b) determine the average convection heat transfer coefficient, convective heat transfer rate, and drag force associated with an l 0.1-m-long, w 0.1-m-wide flat plate for water flow and surface temperatures of ts 50 c and 80 c

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

Answer

You know the right answer?

Consider a flat plate subject to parallel flow (top and bottom) characterized by u 5 m/s, t 20 c. (a...

Questions