Engineering, 04.11.2019 22:31 thebomb2023

Tom watson is a manager for a mcdonald's restaurant. many of his key responsibilities include analyzing data and making key decisions for the success of his store. tom's store has been experiencing decreased sales for breakfast services over the past 3 months. tom is unsure why breakfast revenues are down while lunch and dinner revenues remain unchanged. tom believes that he can drive revenue up by implementing a few different breakfast promotions such as free coffee or hash browns with the purchase of a meal. tom performs an extensive analysis of how continuous changes in breakfast promotions could impact his daily revenue. what type of dss analysis is tom performing? a. optimization analysis b. sensitivity analysis c. transaction anaysis d. goal-seeking analysis

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

Tom watson is a manager for a mcdonald's restaurant. many of his key responsibilities include analyz...

Questions