subject
Engineering, 01.11.2019 04:31 kjdskcd4024

Agas is compressed in a piston-cylinder assembly from p1= 2 bar to p2= 8 bar, v2= 0.02 m^3 in a process during which the relation between pressure and volume is pv^1.3= constant. the mass of the gas is 0.2 kg. if the specific internal energy of the gas increases by 50 kj/kg during the process, determine the heat transfer, in kj. kinetic and potential energies are negligible.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
question
Engineering, 04.07.2019 18:10
Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1
Answers: 1
question
Engineering, 04.07.2019 18:10
Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k
Answers: 2
question
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
You know the right answer?
Agas is compressed in a piston-cylinder assembly from p1= 2 bar to p2= 8 bar, v2= 0.02 m^3 in a proc...
Questions
question
World Languages, 20.11.2020 19:50
question
Arts, 20.11.2020 19:50
question
Health, 20.11.2020 19:50
question
Mathematics, 20.11.2020 19:50
question
Mathematics, 20.11.2020 19:50
question
Mathematics, 20.11.2020 19:50
Questions on the website: 13722366