Engineering, 30.10.2019 06:31 bqg464

2. a hot tub manufacturer wants the thermostat to control water temperature to within one degree when set at 130 degrees fahrenheit. they randomly select 10 hot tubs, set the thermostats to 130, and record the following data with an infrared thermometer that has recently been calibrated. temp 129.9 129.7 130.2 129.7 129.8 130 129.6 131 130.3 129.8 a. using the data above, determine whether the hot tub manufacturer is meeting its temperature control standard? (12points) b. what is the process capability index? (4points) c. what precision statement can you make from part "a and b" (2point) 3. using the data in question 2, what precision statement would you make @ 99.7% confidence if the process is in control. (14points

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point.the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false

Answers: 2

Answer

You know the right answer?

2. a hot tub manufacturer wants the thermostat to control water temperature to within one degree whe...

Questions