Engineering, 30.10.2019 01:31 roudjinapierre214

Abrass alloy is known to have a yield strength of 240 mpa (35,000 psi), a tensile strength of 310 mpa (45,000 psi), and anelastic modulus of 110 gpa (16.0 x 106 psi). a cylindrical specimen of this alloy 15.2 mm (0.60 in) in diameter and 380 mm(15.0 in) long is stressed in tension and found to elongate 19 mm (0.075 on the basis of the information given, is itpossible to compute the magnitude of the load necessary to produce this change in length? if so, calculate the load; if not, explain why.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Air inially occupying a volume of 1 m2 at 100 kpa, 27 c undergoes three internally reversible processes in series. process 1-2 compression to 500 kpa during which pv constant process 2-3 adiabatic expanslon to 100 kpa process 3-1: constant-pressure expansion to 100 kpa (a) calculate the change of entropy for each of the three processes. (b) calculate the heat and work involved in each process. (c) is this cycle a power cycle or refrigeration cycle?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Plan an experiment to measure the surface tension of a liquid similar to water. if necessary, review the ncfmf video surface tension for ideas. which method would be most suitable for use in an undergraduate laboratory? what experimental precision could be expected?

Answers: 2

Answer

You know the right answer?

Abrass alloy is known to have a yield strength of 240 mpa (35,000 psi), a tensile strength of 310 mp...

Questions