subject
Engineering, 25.10.2019 02:43 lbab

Acylindrical fuel rod (k 5 30 w/m∙k) of 2 cm in diameter is encased in a concentric tube and cooled by water. the fuel rod generates heat uniformly at a rate of 100 mw/m3 , and the average temperature of the cooling water is 75°c with a convection heat transfer coefficient of 2500 w/m2 ∙k. the operating pressure of the cooling water is such that the surface temperature of the fuel rod must be kept below 200°c to avoid the cooling water from reaching the critical heat flux (chf). the critical heat flux is a thermal limit at which a boiling crisis can occur that cause overheating on the fuel rod surface and lead to damage. determine the variation of cen98187_ch02_p067-141.indd 133 14/02/14 3: 01 pm 134 heat conduction equation temperature in the fuel rod and the temperature of the fuel rod surface. is the surface of the fuel rod adequately cooled?

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
question
Engineering, 04.07.2019 18:20
Prove the equivalence between the two statements of the 2nd law of thermodynamics (i.e., a violation of one statement leads to the violatio the other statement)
Answers: 2
question
Engineering, 04.07.2019 19:20
The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.
Answers: 3
question
Engineering, 04.07.2019 19:20
Acircular pipe of 30mm outside diameter is placed in an airstream at 30 c and latm pressure. the air moves in cross flow over the pipe at 20 m/s, while the outer surface of the pipe is maintained at 110 c. what is the drag force exerted on the pipe per unit length? what is the rate of heat transfer from the pipe per unit length?
Answers: 1
You know the right answer?
Acylindrical fuel rod (k 5 30 w/m∙k) of 2 cm in diameter is encased in a concentric tube and cooled...
Questions
question
French, 07.10.2019 14:50
question
Mathematics, 07.10.2019 14:50
Questions on the website: 13722367