Engineering, 22.10.2019 21:30 rleiphart1
Asource follower is required to connect a high-resistance source to a load whose resistance is nominally 2 k but can be as low as 1.5 k and as high as 5 k. what is the maximum output resistance that the source follower must have if the output voltage is to remain within ±10% of nominal value? if the mosfet has kn = 2.5 ma/v2 , at what current id must it be biased? at what overdrive voltage is the mosfet operating?
Answers: 1
Another question on Engineering
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
Engineering, 04.07.2019 18:10
Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false
Answers: 3
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
You know the right answer?
Asource follower is required to connect a high-resistance source to a load whose resistance is nomin...
Questions
Mathematics, 21.04.2020 01:46
English, 21.04.2020 01:46
Mathematics, 21.04.2020 01:46
Mathematics, 21.04.2020 01:46
Mathematics, 21.04.2020 01:47
English, 21.04.2020 01:47
