subject
Engineering, 22.10.2019 21:30 greatsavagebeast

Experiments have been conducted to determine local heat transfer coefficients for flow perpendicular to a long, isothermal bar of rectangular cross section. the bar is of width f parallel to the flow, and height g normal to the flow. for reynolds numbers in the range 104 5hg 5 104 , the idfhdyhudjhg nusselt numbers are well correlated by an expression of the form the values of & and p for the front face, side faces, and back face of the rectangular rod are found to be the following: )dfh f/g & p front 0.33 f/g 1.33 0.674 1/2 side 0.33 0.153 2/3 side 1.33 0.107 2/3 back 0.33 0.174 2/3 back 1.33 0.153 2/3 determine the value of the average heat transfer coefficient for the entire exposed surface (that is, averaged over all four faces) of a f 40-mm-wide, g 30-mm-tall rectangular rod. the rod is exposed to air in cross flow at 9 10 m/s, 7 300 k. provide a plausible explanation of the relative values of the face-averaged heat transfer coefficients on the front, side, and back faces.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 08:10
Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed
Answers: 1
question
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
question
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
question
Engineering, 04.07.2019 18:20
The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?
Answers: 3
You know the right answer?
Experiments have been conducted to determine local heat transfer coefficients for flow perpendicular...
Questions
question
Biology, 29.07.2019 11:30
Questions on the website: 13722363