subject
Engineering, 19.10.2019 05:10 tursunovarukhshona

Ch4 and o2 react to form hcho and h2o with a catalyst. the reactants also react to form co2 and h2o under the same conditions. for a basis of 100 mol feed/s and equimolar feed of reactants: i) write the two balanced competing reactions in the reactor; ii). draw and label a flowchart and use a degree-of-freedom analysis based on extents of reaction to determine how many process variables must be specified to calculate the remaining variables; iii). derive expressions for the product stream component flow rates in terms of the extents of the two reactions; iv). calculate the molar composition of the reactor output stream and the selectivity of hcho relative to co2

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 14:10
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
question
Engineering, 03.07.2019 15:10
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
question
Engineering, 04.07.2019 19:10
10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.
Answers: 2
question
Engineering, 06.07.2019 04:10
Areheat rankine cycle operates with water as the working fluid. steam enters the first turbine at 8 mpa and 450°c and exits at 0.8 mpa. it is then reheated to 400°c before entering the second turbine, where it exits at 10 kpa. if the amount of work into the pump is 8.04 kj/kg and the net work per cycle produced is 1410.25 kj/kg, determine the thermal efficiency of the cycle.
Answers: 3
You know the right answer?
Ch4 and o2 react to form hcho and h2o with a catalyst. the reactants also react to form co2 and h2o...
Questions
question
Computers and Technology, 26.08.2019 08:00
question
Mathematics, 26.08.2019 08:00
Questions on the website: 13722363