Engineering, 18.10.2019 22:10 xelynncaldera
Annealing is a process by which steel is reheated and then cooled to make it less brittle. consider the reheat stage for a 100 mm thick plate (r = 7830 kg/m3, cp = 550 j/kg k, k = 48 w/m k). the plate initially is at 200 oc and is to be heated to a minimum temperature of 550 oc. heating is effected in a gas-fired furnace where the products of combustion at t[infinity] = 800 oc maintain a convection heat transfer coefficient of h = 250 w/m k on both surfaces of the plate.
(a) calculate the biot number for this heat transfer process.
(b) can the lumped-capacitance approximation be used to analyze this transient heat transfer process?
(c) assuming that the lowest temperature in the plate is at its midplane, calculate the dimensionless temperature at the midplane of the plate when temperature is 550 oc
(d) using the one-term approximate solution for convective heat transfer into a semi-infinite medium, calculate the fourier number required to achieve a temperature of 550 oc in the steel
(e) calculate the time required to achieve a temperature of 550 oc at the midplane of the plate.
Answers: 1
Engineering, 03.07.2019 14:10
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
Engineering, 04.07.2019 18:10
Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented
Answers: 2
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Annealing is a process by which steel is reheated and then cooled to make it less brittle. consider...
History, 26.09.2019 04:30
History, 26.09.2019 04:30
Social Studies, 26.09.2019 04:30
Mathematics, 26.09.2019 04:30
Chemistry, 26.09.2019 04:30
History, 26.09.2019 04:30
Social Studies, 26.09.2019 04:30
Mathematics, 26.09.2019 04:30
Mathematics, 26.09.2019 04:30
Mathematics, 26.09.2019 04:30
Mathematics, 26.09.2019 04:30
History, 26.09.2019 04:30