Engineering, 18.10.2019 18:30 veronicatrejoaguiler

An undeveloped site occupies a lot that is 1,000 by 436 feet the top of the lot is 10 feet higher than the bottom. the town is considering the development of either a park or an asphalt covered parking lot. the proposal includes drainage studies for 10-year storms and 100-year storms for both the park and the arking lot a. what is the maximum distance that the runoff would travel from the top of the slope to the bottom? b. what is the time of concentration (tc) for this site? (use the kirpirch equation. note: the leading coefficient should be changed from 0.019 to 0.0078 when switching rom meters, as shown in the textbook, to feet c. find the design 10-vr flow for a park d. find the design 100-yr flow for a park e. find the design 10-yr flow for an asphalt parking lot f. find the design 100-yr flow for an asphalt parking lot hint: a range is given for the runoff coefficient (table 10.7). use the median value for the 10-yr event. you ll need to make an adjustment for the 100-yrevent (see pg. 488 of textbook) intensity-duration-frequency curve excerpts recurrence interval 10-y 9 10 12 time of concentration (min)

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Agas contained within a piston-cylinder assembly e end nation about same energy states, 1 and 2, where pi 10 bar, v undergoes two processes, a and b, between the sam 0.1 m3, ui-400 kj and p2 1 bar, v2 1.0 m2, u2 200 kj: process a: process from 1 to 2 during which the pressure- volume relation is pv constant process b: constant-volume process from state 1 to a pressure of 2 bar, followed by a linear pressure-volume process to +20 0 state 2 kinetic and potential energy effects can be ignored. for each of the processes a and b, (a) sketch the process on p-v coordinates, (b) evaluate the work, in kj, and (c) evaluate process the heat transfer, in kj

Answers: 2

Answer

Engineering, 06.07.2019 03:20

Write a technical essay (maximum two pages) about stress concentration. and paste from the textbook. instead, read updated material about this phenomenon and provide a technical evaluation of the different techniques to avoid/reduce such phenomenon. consider in your analysis cutting-edge computational techniques such as fea to study and analyze stress concentrations.

Answers: 2

Answer

Engineering, 06.07.2019 04:10

Cold water (cp=4180j/kg k) leadıng to a shower enters a thin-walled double-pipe heat transfer at 15c at a rate of 0.25kg/s and is heated to 45c by hot water (cp=4190j/kg k) that enters at 100c at the rate of 3kg/s. if the overall heat transfer coefficient is 950w /m2 k , determıne the rate of heat transfer and the heat transfer surface area of the heat exchanger using e - ntu method

Answers: 1

Answer

You know the right answer?

An undeveloped site occupies a lot that is 1,000 by 436 feet the top of the lot is 10 feet higher th...

Questions