Engineering, 16.10.2019 18:30 destiniout04231

Astrain gauge that has a nominal resistance of 350 w and a gauge factor of 1.8 is mounted in an equal-arm wheatstone bridge (equal-arm means that the other 3 resistors also have a 350 w resistance. these 3 resistors are not strain gauges). this strain gauge is mounted to sense axial strain. the bridge output voltage is 1 mv and the input voltage is 5 v. what is the axial strain measured by the strain gauge? if we also have strain in the transverse direction (perpendicular to the axial direction) and this strain is 15% of the axial one, what is the error in the previous axial strain due to a transverse sensitivity of the gauge of 0.05? the gauge factor of 1.8 was obtained from a tensile test on a steel specimen (poisson’s ratio = 0.27).

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

You know the right answer?

Astrain gauge that has a nominal resistance of 350 w and a gauge factor of 1.8 is mounted in an equa...

Questions