Engineering, 15.10.2019 21:30 Caixiayang3613

An experimentalist wishes to measure the resistance rs of a sample located down in a cryostat. two wires, each with resistance r = 10ω, carry an ac current i = 1.0 ma down into the cryostat, through the sample, and back up to ground. the voltage across the sample is measured with a differential amplifier. the actual sample resistance is rs = 0.10ω. 1.0ma r 10ω rs 0.10ω r 10ω − + vout (a) what is the differential voltage at the amplifier inputs? (b) what is the common-mode voltage? (c) suppose the amplifier is similar to the one you will build in lab, with gdiff = 10 and gcm = 0.50. what is the amplitude of the ac signal at vout? (d) if the experimenter assumed that her amplifier was ideal, with gdiff = 10 but gcm = 0, what would she report for the value of rs? (e) what is the minimum cmrr (= gdiff/gcm) her amplifier would need in order to measure rs to an accuracy of 1%?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The higher the astm grain-size number, the coarser the grain is. a)-true b)-false

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Tom is having a problem with his washing machine. he notices that the machine vibrates violently at a frequency of 1500 rpm due to an unknown rotating unbalance. the machine is mounted on 4 springs each having a stiffness of 10 kn/m. tom wishes to add an undamped vibration absorber attached by a spring under the machine the machine working frequency ranges between 800 rpm to 2000 rpm and its total mass while loaded is assumed to be 80 kg a) what should be the mass of the absorber added to the machine so that the natural frequency falls outside the working range? b) after a first trial of an absorber using a mass of 35 kg, the amplitude of the oscillation was found to be 10 cm. what is the value of the rotating unbalance? c) using me-3.5 kg.m, find the optimal absorber (by minimizing its mass). what would be the amplitude of the oscillation of the absorber?

Answers: 3

Answer

You know the right answer?

An experimentalist wishes to measure the resistance rs of a sample located down in a cryostat. two w...

Questions