Engineering, 09.10.2019 17:30 2Dgames

Hot air flows from a furnace through a 0.15 m diameter, thin walled steel duct with a velocity of 3 m/sec. the duct passes through crawlspace of a house, and its un-insulated exterior surface is exposed to quiescent air and surroundings of 0℃. the duct outer surface has an emissivity of 0.5. a) determine the heat loss per unit duct length and the duct wall temperature at the location in the duct for which the mean air temperature is 70℃. b) if the duct is wrapped with a 25 mm thick layer of 85% magnesia insulation, k = 0.05 w/m.°k, and having surface emissivity of = 0.60, what are the duct wall temperature, the outer surface temperature and the heat loss per unit length. use the following correlations for nusselt numbers,

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

The proportional limit is always greater than the yield strength for a material. a)-trune b)- false

Answers: 3

Answer

You know the right answer?

Hot air flows from a furnace through a 0.15 m diameter, thin walled steel duct with a velocity of 3...

Questions