Engineering, 09.10.2019 01:30 valerrry

Arod of diameter d=25mm and thermal conductivity k=60w/(mk) protrudes normally from a furnace wall that is at tw=200°c and is covered by insulation of thickness lins=200mm. the rod is welded to the furnace wall and is used as a hanger to support instrumentation cables. to avoid damaging the cables, the temperature of the rod at its exposed surface, to, must be maintained below a specified operating limit of tmax=100°c. the ambient air temperature is 30°c, and the convection coefficient is 17.0 w/(m2k). a) derive an expression for the exposed surface temperature, to, as a function of the prescribed thermal and geometrical parameters. the rod has an exposed length lo, and the tip is well insulated. b) will a rod of length lo=180mm meet the specified operating limit? if not, which design parameters would you change? note the variables and whether increasing or decreasing them would change to.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

You know the right answer?

Arod of diameter d=25mm and thermal conductivity k=60w/(m*k) protrudes normally from a furnace wall...

Questions