Engineering, 08.10.2019 02:00 rileyeddins1010

An iron bar used for a chimney support is exposed to hot gases at 625 k with the associated convective heat-transfer coefficient of 740 w/m2 ? k. the bar is attached to two opposing chimney walls, which are at 480 k. the bar is 1.9 cm in diameter and 45-cm long. determine the maximum temperature in the bar

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 19:10

The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]

Answers: 3

Answer

Engineering, 06.07.2019 03:20

Aparticle moves along a straight line such that its acceleration is a=(4t^2-2) m/s, where t is in seconds. when t = 0, the particle is located 2 m to the left of the origin, and when t = 2, it is 20 m to the left of the origin. determine the position of the particle when t=4s.

Answers: 1

Answer

Engineering, 06.07.2019 03:30

An ammonia compressor has a 5% clearance volume and displacement rate of 80 l/s and pumps against a condensing temperature of 40°c. for two different temperatures of -10°c and 10°c, compute the mass flow rate of refrigerant assuming the clearance volumetric efficiency applies. discharge specific volume corresponding to-10°c and 10°c are 112.5 l/kg and 95 l/kg, respectively.

Answers: 2

Answer

Engineering, 06.07.2019 05:20

An industrial centrifugal air compressor has 34 radial blades that has no pre-whirl. the tip speed of the blades is 300 m/s, and the radial component of the air velocity at the tip is 150 m/s. air is inducted at 101.3 kpa and a stagnation temperature of 305 k. the mass flow rate is 3 kg/s. consider the power input factor to be equal to 1.04 and a stagnation temperature at the compressor exit of 370 k, if the flow is isentropic. assume cp-1005 j/kg.k. find the power input to the compressor (in kw)

Answers: 3

Answer

You know the right answer?

An iron bar used for a chimney support is exposed to hot gases at 625 k with the associated convecti...

Questions