Engineering, 07.10.2019 22:20 maddigrace3

Need asap
1. what material is specified?

2. what tolerances are allowed on:

(a) decimal dimensions?

(b) fractional dimensions?

(c) angular dimensions?

3. what heat-treating process is required after rough machining?

4. determine overall basic dimensions a b c.

5. what is the radius of all fillets and rounds?

6. compute dimensions d and e .

7. how many holes are .500?

8. how many external threads are to be cut?

9. what thread series is used for the internal and external threads?

10. what does 3/4 - 16unf - 2a - lh mean?

11. what are the upper- and lower-limits of the .7500 diameter portion?

12. what does 1 1/2 - 16un - 3a - lh mean?

13. what does .312 - 18unc - 1b mean?

14. what is the lower-limit diameter of the unthreaded 1 1/20 diameter portion?

15. determine the length of the 1 1/20 - 16 threaded portion.

16. how many holes are to be threaded 10 - 32unf?

17. how deep are the holes to be threaded?

18. give the angle to the horizontal at which the 10 - 32unf holes are to be drilled.

19. give the diameter of the circle on which the 10 - 32unf tapped holes are located.

20. identify the system of dimensioning used on the drawing of the rocker base.

21. change the decimal and angular tolerances so they apply in one direction (1) only. then, determine the upper- and lower-limit dimensions for a , b , c , d , e , and the 45° angle.

Need asap1. what material is specified? 2. what tolerances are allowed on:

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

Answer

Engineering, 03.07.2019 15:10

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

You know the right answer?

Need asap
1. what material is specified?

2. what tolerances are allowed on:
...

Questions