Engineering, 05.10.2019 10:01 RockieLuv7292

The vacuum pump is used to create vacuum in the insulated tank of volume equal to 25 m3. initially the tank is filled with air at temperature 300 k and pressure 1 bar. to support the pump 0.05 kw heater was mounted in the tank. find the minimal power of the pump required to empty the tank within 4 hours. assume that the gas which is leaving the tank is at 350 k. the gas constant for the air is 287 j/kg/k and the air is di-atomic gas. what will be the power if no heating elements are used and the air leaving the tank is at ambient temperature equal to 300 k (due to very slow flow)? which solution is better from energetic point of view?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]

Answers: 3

Answer

Engineering, 06.07.2019 03:20

Write a technical essay (maximum two pages) about stress concentration. and paste from the textbook. instead, read updated material about this phenomenon and provide a technical evaluation of the different techniques to avoid/reduce such phenomenon. consider in your analysis cutting-edge computational techniques such as fea to study and analyze stress concentrations.

Answers: 2

Answer

Engineering, 06.07.2019 04:20

Consider the transfer function for a first-order system g(s)=12(s+7)/(s^2+2s+9) for this system determine: a) poles and zeros of the function, b) the natural frequency and damping ratio, c) the peak value achieved in response to a unit step input, d) the peak time for a unit step input, e) the steady-state system response to a unit step input

Answers: 2

Answer

You know the right answer?

The vacuum pump is used to create vacuum in the insulated tank of volume equal to 25 m3. initially t...

Questions