Engineering, 02.10.2019 00:30 jwhit28

The early steam engines were driven by the atmosphericpressure

acting on the piston fitted into a cylinder filled withsaturated

steam. a vacuum was created in the cylinder by coolingthe cylinder

externally with cold water, and thus condensing thesteam.

consider a piston-cylinder devise with a piston surface areaof

0.1m2 initially with 0.05m3 of saturatedsteam

at the atmospheric pressure of 100kpa. now cold water ispoured

outside the cylinder, and the steam inside starts tocondensing as a

result of heat transfer to the cooling wateroutside. if the piston

is stuck at its initial position, determinethe friction force

acting on the piston, and the amount of heattransfer when the

temperature inside the cylinder drops to30oc.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

The early steam engines were driven by the atmosphericpressure

acting on the piston fitt...

Questions