Engineering, 01.10.2019 23:10 ineedhelp2285

The heat transfer coefficient for hydrogen flowing over a sphere is to be determined by observing the temperature–time history of a sphere fabricated from pure copper. the sphere, which is 20.0 mm in diameter, is at 80°c before it is inserted into the gas stream having a temperature of 27°c. a thermocouple on the outer surface of the sphere indicates 50°c 97 s after the sphere is inserted into the hydrogen.(a) what is the value of the specific heat of the copper at the average temperature of the process, in j/kg·k? (b) what is the value of the lumped thermal capacitance of the sphere, in j/k? (c) solve for the thermal time constant, in sec.(d) what is the value of the heat transfer coefficient, in w/m2· k? (e) what is the value of the biot number?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

Answer

You know the right answer?

The heat transfer coefficient for hydrogen flowing over a sphere is to be determined by observing th...

Questions