Engineering, 01.10.2019 05:00 roseemariehunter12

Ay-connected balanced three-phase source is feeding a balanced three-phase load. the voltage and current of the source coil are = 325 sin( + 0.393) [v] = 22.6 sin( + 0.785) [a] calculate the following: a) the rms phase voltage. b) the rms line-to-line voltage. c) the rms current in the source. d) the rms current in the transmission line. e) the frequency of the supply. f) the power factor at the source side, state leading or lagging. g) the three-phase real power delivered to the load. h) the three-phase reactive power delivered to the load. i) if the load is connected in delta configuration, calculate the load impedance. j) in what regions of the world is this a typical residential voltage?

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

Answer

You know the right answer?

Ay-connected balanced three-phase source is feeding a balanced three-phase load. the voltage and cur...

Questions