subject
Engineering, 26.09.2019 16:20 samueldfhung

Water is poured into a bucket according to the rate f of t equals the quotient of 7 plus t and the quantity 2 plus t , and at the same time empties out through a hole in the bottom at the rate e of t equals the quotient of the natural log of the quantity t plus 4 and the quantity t plus 2 , with both f(t) and e(t) measured in pints per minute. how much water, to the nearest pint, is in the bucket at time t = 5 minutes? you must show your setup, but can use your calculator for all evaluations.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 14:10
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
question
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
question
Engineering, 04.07.2019 18:20
Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k
Answers: 3
question
Engineering, 04.07.2019 19:10
Tom is having a problem with his washing machine. he notices that the machine vibrates violently at a frequency of 1500 rpm due to an unknown rotating unbalance. the machine is mounted on 4 springs each having a stiffness of 10 kn/m. tom wishes to add an undamped vibration absorber attached by a spring under the machine the machine working frequency ranges between 800 rpm to 2000 rpm and its total mass while loaded is assumed to be 80 kg a) what should be the mass of the absorber added to the machine so that the natural frequency falls outside the working range? b) after a first trial of an absorber using a mass of 35 kg, the amplitude of the oscillation was found to be 10 cm. what is the value of the rotating unbalance? c) using me-3.5 kg.m, find the optimal absorber (by minimizing its mass). what would be the amplitude of the oscillation of the absorber?
Answers: 3
You know the right answer?
Water is poured into a bucket according to the rate f of t equals the quotient of 7 plus t and the q...
Questions
question
Social Studies, 03.11.2020 04:50
question
Mathematics, 03.11.2020 04:50
question
Mathematics, 03.11.2020 04:50
question
Mathematics, 03.11.2020 04:50
question
Mathematics, 03.11.2020 04:50
question
Mathematics, 03.11.2020 04:50
Questions on the website: 13722367