Engineering, 21.09.2019 23:20 graciewyatt6833

Sketch t-s and p-v diagrams for the otto cycle.

Answers: 2

Show answers

Answers

Answer from: keidyhernandezm

see picture

Explanation:

The Otto cycle is a theoretical approach to the explosion motors (the ones in most cars). It’s a process that includes 4 steps.

1.Admission (A-B): here the piston goes down to allow the mix (air +fuel) enter in combustion camera. In this process the pressure, since the piston is open, is constant but volume is increasing. Temperature and entropy are constant (not temperature change, not entropy change here)

2.Compression (1-2): Here the piston goes up to compress the mix (air +fuel). Since this process is very fast we can say that there is no heat exchange so, it’s an adiabatic process. Both pressure and volume are changing. Temperature raises but entropy is constant because it is an adiabatic process.

3.Combustion (2-3): when the mix has reached a certain temperature (ignition temperature) the combustion of the mix (air+ fuel) occurs. We can consider that the volume is constant because the process is very fast while both temperature and pressure are increasing. The entropy can be estimated using the expression for entropy while volume is constant

$S=n*c_{v}*ln(\frac{T}{T_{0}}) + n*R*ln(\frac{V}{V_{0}})$

Clearing T from the expression we have:

$T=T_{0}(\frac{V}{V_{0}})^{y-1} e^{\frac{S}{nc_{v}}}$

When V is constant the temperature and entropy are related in an exponential behavior.

4.Expansion (3-4): The high temperature makes the piston goes down increasing the volume and decreasing the pressure of the system. Since this process occurs very fast we can say that there is no heat exchange so it’s adiabatic and the entropy is constant.

5.Escape (4-1): In this step, the combustion gases leaves the combustion camera (at high temperature) and are replaced with another admission of the mix (air+fuel) (low temperature). Since the among of mix that leaves the system is the same that enter in it, we can say that the volume remains constant while temperature and pressure decrease. The entropy keeps the exponential relationship with temperature for a process where volume is constant.

Sketch t-s and p-v diagrams for the otto cycle.

Answer from: Quest

Because if a good speech is delivered badly it can bore the audience, confuse them, or make them distrust the speakeri think they all come back to this one, except that last answer because that is false. if your audience starts making fun of you or gets distracted it is because they are either bored, confused or distrust you.

Answer from: Quest

answer:

i dont know the answer but good luck

explanation:

Another question on Engineering

Engineering, 04.07.2019 18:10

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

Answer

Engineering, 04.07.2019 18:20

How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s

Answers: 2

Answer

Engineering, 04.07.2019 19:10

What is creep? what is stress relaxation?

Answers: 1

Answer

Engineering, 06.07.2019 02:30

On solidification from a melt, the polymer polyethylene forms a semi-crystalline spherulite structure. (i) sketch an individual spherulite and label the amorphous and crystalline regions. (ii) draw a schematic to show the changes in specific volume with temperature during cooling from the melt, comparing it to the theoretical extremes of fully crystalline and fully amorphous (indicate tm and tg)

Answers: 2

Answer

You know the right answer?

Sketch t-s and p-v diagrams for the otto cycle....

Questions