Engineering, 20.09.2019 19:30 marissalwilliams3

4. the hubert h. humphrey metrodome in minneapolis, minnesota opened in 1982 at a cost of $55 million. to prepare for the footings, etc. 300,000 cubic yards of dirt were removed. its inflatable roof covers 10 acres and its interior column is 60 × 106 cubic feet. during construction, 40× 103 cubic yards of concrete, 11.9 × 103 tons of reinforcing steel and 5 × 102 tons of structural steel were utilized. the roof material includes an outer layer of teflon-coated fiberglass and an inner layer of woven fiberglass. given this information, answer the following: a. if removed evenly over the 10 acres, how deep of a hole would be formed as a result of the excavation? b. what is the total mass of the concrete and steel in lbm? c. if the two-layer fiberglass roofing material has a mass of 0.6667 lbm/ft2, what is the total mass of the roof? d. if 10 inches of wet snow collected on the roof as happened in 1982, what is the added mass to the roof? assume 1 inch of water equals 10 inches of snow.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Acircular aluminum shaft mounted in a journal is shown. the symmetric clearance gap between the shaft and journal is filled with sae 10w-30 oil at t 30°c. the shaft is caused to turn by the attached mass and cord. develop and solve a differential equation for the angular speed of the shaft as a function of time.

Answers: 2

Answer

You know the right answer?

4. the hubert h. humphrey metrodome in minneapolis, minnesota opened in 1982 at a cost of $55 millio...

Questions