Engineering, 18.09.2019 18:20 iklassibrahim123

Chapter 3 discusses methods to assess the quality of simulations. you learned about three different views of simulation quality. suppose you lead a task force that is developing a simulation to provide strategic planning recommendations for property use zoning for a county of 750,000 residents. the zoning board and county commissioners want a simulation that allows them to assess the impact of various zoning decisions based on a variety of dynamic factors, including age, race, education, and income status. which of the three views discussed would provide the best quality assessment for this type of simulation? how would you ensure the highest level of accuracy with your simulation, and how would you go about determining accuracy? create a 3-page paper (3-page main body, does not include the title page or references page), apa formatted the answers the following question: as indicated above, identify which of the three views discussed in the chapter that would provide the best quality assessment for the situation described above, and explain your decision. how would you ensure the highest level of accuracy with your simulation, and how would you go about determining accuracy?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?

Answers: 3

Answer

Engineering, 04.07.2019 19:20

To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.

Answers: 1

Answer

You know the right answer?

Chapter 3 discusses methods to assess the quality of simulations. you learned about three different...

Questions