subject
Engineering, 14.09.2019 04:30 maritsaledesma

Asteel shaft 5 m long, having a diameter of 50 mm, is to transmit power at a rotational speed of 600 rev/min. if the maximum shear stress is limited to 60mn/m^2. determine the following. (i) the maximum power that can be transmitted. (ii) the corresponding angle of twist. assume the modulus of rigidity for steel is 80 gn/m^2

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
question
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
question
Engineering, 04.07.2019 18:20
For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.
Answers: 1
question
Engineering, 04.07.2019 18:20
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
You know the right answer?
Asteel shaft 5 m long, having a diameter of 50 mm, is to transmit power at a rotational speed of 600...
Questions
question
Mathematics, 20.03.2020 11:40
question
Mathematics, 20.03.2020 11:40
Questions on the website: 13722363