subject
Engineering, 14.09.2019 02:30 taylorlanehart

Which of the following describes fibers? a)- single crystals with extremely large length-to-diameter ratios. b)- polycrystalline and amorphous materials with small diameters. c)-metal wires having relatively large diameters.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
question
Engineering, 06.07.2019 03:20
Write a technical essay (maximum two pages) about stress concentration. and paste from the textbook. instead, read updated material about this phenomenon and provide a technical evaluation of the different techniques to avoid/reduce such phenomenon. consider in your analysis cutting-edge computational techniques such as fea to study and analyze stress concentrations.
Answers: 2
question
Engineering, 06.07.2019 03:20
Aparticle moves along a straight line such that its acceleration is a=(4t^2-2) m/s, where t is in seconds. when t = 0, the particle is located 2 m to the left of the origin, and when t = 2, it is 20 m to the left of the origin. determine the position of the particle when t=4s.
Answers: 1
question
Engineering, 06.07.2019 03:30
The catalogue for a refrigerant 22, four-cylinder, hermetic compressor operating at 29 r/s. a condensing temperature of 40°c and an evaporating temperature of -4°c shows a refrigeration capacity of 115 kw. at this operating point, the motor (its efficiency is 90 percent) draws 34.5 kw. the bore of the cylinders is 87 mm and the piston stroke is 70 mm. the performance data are based on 8°c of sub-cooling of the liquid leaving the condenser. compute (a) the actual volumetric efficiency and (b) the compression efficiency.
Answers: 2
You know the right answer?
Which of the following describes fibers? a)- single crystals with extremely large length-to-diamete...
Questions
question
Mathematics, 05.05.2020 19:39
question
English, 05.05.2020 19:39
Questions on the website: 13722367