Engineering, 14.09.2019 00:30 Destinyb9806
Ametallic material with yield stress of 140 mpa and cross section of 300 mm x 100 mm, is subjected to a tensile force of 8.00 mn. will the sample experience plastic deformation? you must justify your answer.
Answers: 2
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 08:10
Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed
Answers: 1
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
Engineering, 04.07.2019 18:10
Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.
Answers: 2
Ametallic material with yield stress of 140 mpa and cross section of 300 mm x 100 mm, is subjected t...
Physics, 25.11.2020 09:20
Health, 25.11.2020 09:20
Computers and Technology, 25.11.2020 09:20
History, 25.11.2020 09:20
Advanced Placement (AP), 25.11.2020 09:20
Mathematics, 25.11.2020 09:20
Mathematics, 25.11.2020 09:20
Mathematics, 25.11.2020 09:20
Mathematics, 25.11.2020 09:20
History, 25.11.2020 09:20
Chemistry, 25.11.2020 09:20
Mathematics, 25.11.2020 09:20
Advanced Placement (AP), 25.11.2020 09:20