Engineering, 13.09.2019 23:30 lamashermosa23

Acaliper brake is required for the front wheels of a passenger car with a braking capacity of 500 nm for each brake. preliminary design estimates have set the brake geometry as ri = 110 mm1 and θ = 43°. pads with a coefficient of friction of 0.38 have been selected. each pad is actuated by means of a hydraulic cylinder of nominal diameter 25.4 mm. determine: a)- the required actuating force, b)- the average and the maximum contact pressures, c)- the required hydraulic pressure for brake actuation. take the outer radius of the brake to be that of the bugatti chiron. (420.0 mm front brake diameter 400.0mm rear brake diameter)

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 19:20

To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.

Answers: 1

Answer

Engineering, 06.07.2019 03:20

Explain in your own word the concept of a solid solution, in alloys, and how it can be created.

Answers: 3

Answer

Engineering, 06.07.2019 05:20

An industrial centrifugal air compressor has 34 radial blades that has no pre-whirl. the tip speed of the blades is 300 m/s, and the radial component of the air velocity at the tip is 150 m/s. air is inducted at 101.3 kpa and a stagnation temperature of 305 k. the mass flow rate is 3 kg/s. consider the power input factor to be equal to 1.04 and a stagnation temperature at the compressor exit of 370 k, if the flow is isentropic. assume cp-1005 j/kg.k. find the power input to the compressor (in kw)

Answers: 3

Answer

Engineering, 06.07.2019 05:30

There is a metal plate with thickness, thermal conductivity, density, and specific heat of 10 mm, 200 w/m.°c, 2500 kgrn3, and 900 j/kg.k, respectively. it has an initial uniform temperature of 22°c and is being heated in an oven for 2 minutes. air in the oven is maintained at 900 c with convection heat transfer coefficient of 190 w/m.k. determine the temperature of the plate when it is removed from the oven.

Answers: 3

Answer

You know the right answer?

Acaliper brake is required for the front wheels of a passenger car with a braking capacity of 500 nm...

Questions