Answers: 3
Another question on Engineering
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
Engineering, 04.07.2019 18:10
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
You know the right answer?
What is the only thing that cáue a change in qd?...
Questions
Health, 26.01.2021 01:00
Mathematics, 26.01.2021 01:00
Social Studies, 26.01.2021 01:00
Mathematics, 26.01.2021 01:00
History, 26.01.2021 01:00
History, 26.01.2021 01:00
Chemistry, 26.01.2021 01:00
History, 26.01.2021 01:00
Physics, 26.01.2021 01:00
Mathematics, 26.01.2021 01:00
Mathematics, 26.01.2021 01:00
Mathematics, 26.01.2021 01:00
Physics, 26.01.2021 01:00
Mathematics, 26.01.2021 01:00
