Engineering, 13.09.2019 23:30 alexis123420
Air flows through a 3 m long, 15 cm x 2 cm duct at 2 m s^-1. if the duct surface is held constant at 25°c and the inlet air temperature is 75°c, use an appropriate correlation to calculate the outlet temperature of the water and the rate of heat transfer.
Answers: 1
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
Engineering, 04.07.2019 18:10
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
Engineering, 04.07.2019 18:20
For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.
Answers: 1
Air flows through a 3 m long, 15 cm x 2 cm duct at 2 m s^-1. if the duct surface is held constant at...
Health, 14.10.2020 14:01
Mathematics, 14.10.2020 14:01
Mathematics, 14.10.2020 14:01
Mathematics, 14.10.2020 14:01
English, 14.10.2020 14:01
History, 14.10.2020 14:01
Biology, 14.10.2020 14:01
Mathematics, 14.10.2020 14:01
Mathematics, 14.10.2020 14:01
English, 14.10.2020 14:01
History, 14.10.2020 14:01
Chemistry, 14.10.2020 14:01