subject
Engineering, 13.09.2019 01:30 morenoozzie

Aparticle of mass m is acted upon by a net force f. as a result of the force, the particle starts from rest and moves along a curved path for which the acceleration relative to an inertial cartesian coordinate system with an origin at the location where the particle is at rest is given by a = x i^+ yj^+ z k^with x = at, y = b + ct, and z = d where a, b, c, and d are constants. you may assume that the units associated with t are seconds and the units associated with x, y, and z are m/s^2.
(a) what are the units of a, b, c, and d?
(b) determine the velocity and position as functions of time.
(c) if the numerical values of a, b, c, and d are 0.6, 1.8, -0.36, and 0 respectively, plot the path of the particle for 0 s lessthanorequalto t lessthanorequalto 10 s.
(d) when does ymaximum occur and what is its value?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
question
Engineering, 04.07.2019 18:20
Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?
Answers: 2
question
Engineering, 04.07.2019 19:10
How to increase the thermal officiency of an ideal simple rankino cycle? among these methods, which one is the best and why?
Answers: 2
question
Engineering, 04.07.2019 19:20
Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 Ă— 105?
Answers: 2
You know the right answer?
Aparticle of mass m is acted upon by a net force f. as a result of the force, the particle starts fr...
Questions
question
Mathematics, 17.04.2020 22:49
question
History, 17.04.2020 22:50
Questions on the website: 13722362